Installation

• Turn off the water: Ensure both the hot and cold water taps in your shower are completely turned off.
• Remove the shower head: Unscrew your existing shower head from the shower pipe (or unscrew the shower hose if you have a handheld model) by turning it counter clockwise. You may need an adjustable wrench if it is stuck, but it is typically hand-tight. 
• Check the washers: Make sure the rubber washer (O-ring) is sitting securely inside the inlet of your Nemo filter. 
• Attach the Nemo filter: Screw the Nemo filter onto the shower pipe (or arm) by turning it clockwise. Hand-tighten it until it is snug. Do not overtighten with tools, as this can damage the plastic threads.
• Reattach the shower head: Screw your shower head (or hose) onto the bottom end of the Nemo filter. Hand-tighten firmly until secure. 

Check for Leaks: If water drips from the connection points, turn off the water, unscrew the fitting, and ensure the rubber washer is perfectly flat inside the connection. You can also apply a few turns of plumber's tape to the shower arm threads before installing if you notice a persistent drip.

Note: The filter will add 14cm to your shower connection. 

Filter Replacement: The built-in vitamin and sediment filter typically lasts between 30 to 60 days, depending on your water quality and usage. 

To see exactly how quick and easy the setup is visually, check out this video tutorial: